Modify protected nodes

During the setup process you identified the nodes you wanted to protect. From time to time you might need to change the settings on these nodes.

The PROTECTION CONFIG tab on a DR Appliance is slightly different from its HA counterpart. The DR version shows the HA Appliance’s backup retention time as well as its own backup retention time. The DR version does not show a protection disabled status because this concept does not exist on a DR Appliance.

To edit a protected node (HA Appliance):

1.	Log on to the HA Appliance’s onQ Portal.

2.	Click the PROTECTION CONFIG tab.

3.	Select the node that you want to modify, then click MODIFY.

The Modify a Protected Node page appears.

 

4.	Make your changes to the node parameters. You cannot change the Hostname field from the MODIFY window.

5.	Click SAVE to save your changes and return to the PROTECTION CONFIG tab.

A newly modified protected node appears in the list.

6.	Restart protection, if applicable.

To edit a protected node (DR Appliance):

1.	Log on to the DR Appliance’s onQ Portal.

2.	Click the PROTECTION CONFIG tab.

3.	Select the node that you want to modify, then click MODIFY.

The Modify a Protected Node page appears.

4.	Specify values for the node parameters.

You cannot change the Hostname field from the MODIFY window.

5.	Click SAVE to save your changes and return to the PROTECTION CONFIG page.

A newly modified protected node appears in the list.

v3.6 HF2