Enable protection of nodes

When you re-enable protection, backups resume and subsequent RN rebuilds are based on the retained RN.

To enable protection of a node when Protection is On:

1.	Log on to the HA Appliance’s onQ Portal.

2.	Go to DASHBOARD tab > PROTECTED NODES page.

3.	Unlock the page.

4.	Do one of the following:

•	(All PNs) Click on the ENABLE ALL button at the bottom of the page, then click Disable Protection/Enable Protection to change protection for all PNs.

•	(Single PN) Locate the Protection Disabled column. When you click a button in this column, protection toggles between enabled and disabled for the indicated node.

A check mark appears in the field if protection is disabled. Otherwise it is blank.

v3.6 SP1