Add protected nodes manually

When you enroll protected nodes, onQ automatically adds them to the onQ Manager, among other things; therefore, you don’t need to add them manually. However, there are reasons why you might want to add a protected node manually:

•

You attempted to enroll the protected node, but the installer refused to add the node because there is not enough disk space. Remember, onQ needs disk space for both the protected node’s virtual machine (vdisk) and the protected node’s data, which is stored in the repository. The amount needed is 1.5 x the used disk space on the protected node. If you are certain that the data will not grow, you can add the node manually.

•	You want a protected node to appear in the onQ Portal’s list of protected nodes but don’t want to enroll the nodes yet.

•	You previously enrolled this PN, but deleted it from the onQ Appliance’s configuration.

To add a protected node to the list:

1.	Log on to the HA Appliance’s onQ Portal.

2.	Stop protection.

You can only add to the list of protected nodes when Protection is OFF.

3.	Click the PROTECTION CONFIG tab.

4.	Click the plus button (+).

5.	From the Add a Protected Node dialog, type the PN’s host name, and specify values for the node parameters, then SAVE.

If onQ successfully added the Protected Node, a confirmation message appears:

6.	From the PROTECTION CONFIG tab, confirm that the newly added protected node appears in the list.

7.	If you’d eventually like to protect this node, you must stop protection, then enroll the protected node.

8.	Restart protection.

v3.8 HF1