Change iDRAC network configuration iDRAC (Integrated Dell Remote Access Controller) is a card on the onQ Appliance. This hardware enables Quorum Support to observe the onQ Appliance boot. If your onQ Appliance model is a T20, you do not have iDRAC. All other models have either an iDRAC6 or iDRAC7. To change iDRAC’s network configuration: This procedure is intended for Quorum Support only. Unless instructed to do so by Quorum Support, do not change iDRAC’s network configuration. 1. Log on to the onQ Appliance’s onQ Portal. You must log on as varadmin user. 2. Click the APPLIANCE CONFIG tab > HYPERVISOR page. 3. Click the iDRAC button. The iDRAC dialog appears. The onQ Portal displays an error if your onQ Appliance does not have iDRAC. If you know that the onQ Appliance has iDRAC, click the iDRAC button again: Sometimes a temporary networking glitch can cause iDRAC to become unavailable. 4. Click MODIFY, make your changes, then SAVE.
