Step 4: Connect the Appliance to your network

To connect the onQ Appliance:

1.	Disconnect the standalone computer and connect the onQ Appliance to your target network using the active RJ‑45 connection.

2.	Verify that you can launch the onQ Portal.

After the onQ Appliances reboot, you should be able to launch the onQ Portal from a browser anywhere on your network to the onQ local and onQ remote addresses (or names, if DNS is properly configured) that were configured above.

3.	Reboot the onQ Appliance.

Next Step:

Step 5: Change hypervisor’s NTP server

v3.8 SP1