Monitor disk space and memory usage
onQ can report on the disk usage of the onQ Appliance’s Repository and disk and memory usage of recovery nodes through the onQ Portal as outlined below, or through the onQ Monitor as outlined in
Monitor multiple onQ Appliances.
When the onQ Appliance was pre‑configured, a specific amount of disk space was allocated to the
Repository for snapshots. You cannot change this allocation.
To determine disk space usage of protected nodes:
1. Log on to the HA’s onQ Portal.
2. Go to DASHBOARD tab > PROTECTED NODES page.
A
Disk Usage bar appears toward the bottom of the page. This bar shows the percentage disk usage on onQ, in two ways: a percentage figure and a corresponding bar graph.
Disk usage is calculated based on the disk usage of all the protected nodes that are running.
To determine disk space usage of recovery nodes:
1. Log on to the HA’s onQ Portal.
2. Go to DASHBOARD tab > RECOVERY NODES page.
Statistics appears toward the bottom of the page..
To determine disk space available to the Repository:
1. Log on to either the HA Appliance’s onQ Portal or the DR Appliance’s onQ Portal.
2. Go to APPLIANCE CONFIG > ADVANCED button > REPOSITORY page.
Free Space indicates the amount of space that the Repository can grow.
