Disable protection of nodes
If you disable protection, the most recent re-build of the recovery node is retained but backups are suspended.
If you disable protection while a backup is in progress or an RN is being rebuilt, that process continues to completion but further backups are suspended. You can
re-enable protection at any time.
To disable protection of a node when Protection is On:
1. Log on to the HA’s onQ Portal.
2. Go to DASHBOARD tab > PROTECTED NODES page.
4. Do one of the following:
• (All PNs) Click on the DISABLE ALL button at the bottom of the page, then click DISABLE to change protection for all PNs.
• (Group of PNs) For the group, click the
Protection Disabled (
) button.
• (Single PN) Locate the Protection Disabled column. When you click a button in this column, protection toggles between enabled and disabled for the indicated node.
A
check mark appears in the field if protection is disabled. Otherwise it is blank.
To disable protection of a node when Protection is Off:
1. Log on to the HA’s onQ Portal.
2. From the PROTECTION CONFIG tab, select the node, then click the MODIFY button.
3. Select the Disable Protection?: Yes radio button, then SAVE.