Enable protection of nodes
If you subsequently
disabled protection of a PN, you can re‑enable at any time. When you re-enable protection, backups resume and subsequent RN rebuilds are based on the retained RN.
To enable protection of a node when Protection is On:
1. Log on to the HA’s onQ Portal.
2. Go to DASHBOARD tab > PROTECTED NODES page.
4. Do one of the following:
• (All PNs) Click on the ENABLE ALL button at the bottom of the page, then click ENABLE to change protection for all PNs.
• (Single PN) Locate the Protection Disabled column. When you click a button in this column, protection toggles between enabled and disabled for the indicated node.
A
check mark appears in the field if protection is disabled. Otherwise it is blank.