Deployment : (Workflow) Install onQ Appliances
  
(Workflow) Install onQ Appliances
Use this procedure to set up your onQ Appliances. These instructions apply to each onQ Appliance, whether it provides high availability (HA) or disaster recovery (DR) protection.
Install your onQ Appliance in the environment in which it is to be used. If you have problems during setup, go to Deployment Problems.
To set up your onQ Appliances, perform the following sequence of tasks:
Task
For instructions, Go to...
1. Get an overview of the installation process.
Installation Overview
2. Collect information about your site(s)
Step 1: Prepare to install
3. If not pre-configured, configure the onQ Appliance.
Step 2: Configure the onQ Appliances
4. (Hybrid Cloud Only) Create a VPN connection to your DR Appliance so that you can access its web portal.
Step 3: (Hybrid Cloud Only) Create VPN connection to Hybrid Cloud
5. Connect the onQ Appliance to your network.
Step 4: Connect the Appliance to your network
6. Change hypervisor’s NTP server
Step 5: Change hypervisor’s NTP server
7. Enroll the protected nodes you want to protect.
Step 6: Enroll protected nodes
8. (onQ Flex only) Change the RN type or build policy to reflect your company’s preferred RTO objective and cost.
Step 7: (onQ Flex) Modify RN Type and Build Policy
9. Configure the boot order for your recovery nodes.
Step 8: Configure RN startup dependencies
10. Start protection on the nodes.
Step 9: Start automated protection process
11. (Optional) Install onQ Archive Vault, if you intend to archive backups.
After the hardware is up and running, refer to the AV online help for configuration instructions. For supported configurations, go to Archive Vault Configuration Support.
12. (Recommended) Test your existing backup and recovery procedures using an RN in test mode.
See also: